Above the flash point, explosive vapo r-air Cool. Do NOT let this chemical enter the environment. Contact Lot and Batch Numbers can be found on a product's label Site Use Terms The substance can form explosive peroxides. If your [1 à 4] Le styrène est un liquide incolore à jaunâtre, visqueux. Use carbon dioxide. See Chemical Dangers. -021. Journals | Attacks rubber, copper and copper alloys. Approximately 25 million tonnes of styrene were produced in 2010, increasing to around 35 million tonnes by 2018. Flammable. It is strongly advised not to let the chemical enter into the environment. Â© ILO and WHO 2017. 63, # 2 p. 347 - 352. In case of fire: keep drums, etc., cool by spraying with water. All Rights Reserved. Questions? copolymères acrylonitrile-butadiène-styrene (ABS), styrène-acrylonitrile (SAN), méthacrylate de méthyle-butadiène-styrène (MBS) ; caoutchoucs synthétiques styrène-butadiène (SBR) ; polyesters insaturés et polyesters insaturés renforcés (par exemple aux fibres de verre ou GRP). Wear safety goggles or eye protection in combination with breathing protection. An Optically Driven Bistable Janus Rotor with Patterned Metal Coatings. and having a fash point of 31oC, styrene is classieed as a fammable substance, which in use may form fammable/explosive vapour-air mixtures. See Notes. Certificate of Analysis (COA) Please Enter a Lot Number. View Sample COA. See Notes. Auto-ignition temperature: 490°C Explosive limits, vol% in air: 0.9-6.8 Octanol/water partition coefficient as log Pow: 3.0 EXPOSURE & HEALTH EFFECTS; Routes of exposure The substance can be absorbed into the body by inhalation of its vapour. Then store and dispose of according to local regulations. following the words 'Lot' or 'Batch'. Exposure to the substance may increase noise-induced hearing loss. UN Classification Effects of short-term exposure The substance is irritating to the eyes, skin and respiratory tract. 62K1064 – you will only find the COO if Store only if stabilized. First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention. P201-P210-P261-P280-P304 + P340 + P312-P308 + P313, Journal of the American Chemical Society, , vol. This generates fire and explosion hazard. NO open flames, NO sparks and NO smoking. 103, # 21 p. 6415 - 6422, Bulletin of the Chemical Society of Japan, , vol. May accumulate static electricity. About Us | Vinylbenzene, ReagentPlus is a registered trademark of Sigma-Aldrich Co. LLC. with the financial assistance of the European Commission. Preliminary experiments have indi... Bistable rotation is realized for a gold-coated Janus colloidal particle in an infrared optical trap. K9. Product Classification | Keep in the dark. Routes of exposure © 2020 Merck KGaA, Darmstadt, Germany and/or its affiliates. Transportation Above 31Â°C explosive vapour/air mixtures may be formed. Effects of long-term or repeated exposure Styrene is the precursor to polystyrene and several copolymers. Effects of short-term exposure Separated from incompatible materials. STABILITY AND REACTIVITY Reactivity: This product contains inhibitor at 10 ppm and the liquid can be considered stable at room temperature. Physical State; Appearance Bulk Quote-Order Product. Monodisperse, surfactant-free polymer spheres for use as colloidal crystal templates can be easily obtained in reasonably large quantities. If you find a lot number with a filling-code such as For other typical parameters, the reader is referred to Table 1: Typical Physical Properties of Styrene. Selling Leads | The substance defats the skin, which may cause dryness or cracking. Articles of Styrene are included as well. The substance is toxic to aquatic organisms. Chemical dangers Typical synthesis methods for poly(methyl methacrylate) (PM...Melissa A. FierkeMaterial Matters 2008, 3.1, 13.Keywords: Emulsion polymerization, Polymerization reactions, Precipitation, Sol-gel. Explosion: Sealed containers may rupture when heated. In many cases a COA can be faxed Boiling point: 145Â°C Melting point: -30.6Â°C Relative density (water = 1): 0.91 Solubility in water, g/100ml at 20Â°C: 0.03 Vapour pressure, kPa at 20Â°C: 0.67 Relative vapour density (air = 1): 3.6 Relative density of the vapour/air-mixture at 20Â°C (air = 1): 1.02Flash point: 31Â°C c.c.Auto-ignition temperature: 490Â°C Explosive limits, vol% in air: 0.9-6.8Octanol/water partition coefficient as log Pow: 3.0. presented with a COA Request form. Depending on the degree of exposure, periodic medical examination is suggested. Gives off irritating or toxic fumes (or gases) in a fire. COLOURLESS-TO-YELLOW OILY LIQUID. Store in an area without drain or sewer access. Fireproof. Dizziness. Molecular mass: 104.2 In some cases, a COA may not be available on-line. to you upon submission of this form. MSDS/SDS Database Search | Exposure at high levels could cause unconsciousness. Disclaimer, Copyright © 2018 ChemSrc All Rights Reserved. Formula: C8H8 / C6H5CHCH2 Flash point: 31°C c.c. Mechanism of chemical activation of sodium chloride in the presence of amino acids. Son odeur, détectable des 0,15 ppm, Customer Service, Synonym: Styrene and Functionalized Styrene Monomers, P201-P210-P261-P280-P304 + P340 + P312-P308 + P313, multi-purpose combination respirator cartridge (US), Application Note: Preparation of Monodisperse Polymer Spheres. search was unable to find the COA you are looking for, you will be Phenylethylene, Our team of scientists has experience in all areas of research including Life Science, Material Science, Chemical Synthesis, Chromatography, Analytical and many others.